Craftsman Generator Seals and Gaskets

Craftsman Generator Gasket-Exhaust

Craftsman Generator Air Cleaner Gasket

★★★★★

★★★★★

3 Reviews

The Air Cleaner Gasket is used to provide a seal between the air cleaner base, and carburetor. It's a gray, composite material part, which is rated as "Easy" to install and will require a screw driver, pliers, socket set, and nut driver. It attaches between the base of the air cleaner assembly and carburetor. If broken, damaged or worn down it will allow dirt to enter the carburetor, causing performance issues. If this happens, replace it. Refer to your make, model and diagrams to check if this is the right part.

Craftsman Generator Seal,Oil

★★★★★

★★★★★

1 Review

The Oil Seal is a manufacturer-approved rubber part which provides a seal between the crankcase and crankshaft by attaching around the axle shaft on the crankhouse housing. Installation is rated as "Medium" difficulty and requires a screw driver, wrench set and seal puller. A broken seal will cause a leak, and the part must be replaced. Refer to your make, model and diagram to ensure you're choosing the right part. This part comes in black and gray.

Craftsman Generator Gasket-Rocker Cover

Craftsman Generator Gasket-Intake

Craftsman Generator Gasket-Intake

Craftsman Generator Seal-Oil This OEM Oil Seal is an individually sold rubber part which is attached around the axis shaft on the crankcase housing to provide a proper seal. A broken seal will lead to a leak, and the part should be replaced. Installation is rated as "Medium" difficulty by customers, and will require a screwdriver, wrenchset and seal puller. Refer to your make, model and diagrams to ensure you've chosen the correct part. This model comes in black and grey.

Craftsman Generator Gasket-Cylinder Head The cylinder head gasket, also known just as the head gasket, is an OEM part sold individually. Grey in color, the head gasket provides a seal between the cylinder head and the engine block in your engine. Over time, it can become damaged due to wear. You may also need to replace this part any time you have had to remove the cylinder head for any other reason, as the gasket is a one time use. If you suspect your head gasket is damaged, perform a compression test. In doing so, you may hear air escaping from the head gasket area, and you will know this part is responsible. Symptoms that can be exhibited if this part needs replacing include an engine lacking power. Most of our customers thought this was a medium-difficulty repair. The repair requires a wrench or sockets and a torque wrench. When re-installing your head gasket, torque in an alternating patter to the manufacturer specifications for a proper seal.

Craftsman Generator Gasket-Cylinder Head

Craftsman Generator Gasket-Breather