Admiral Washer Knobs

Videos!

Your Price

$11.09

Admiral Washer D-Shaped Knob Insert

★★★★★

2 Reviews

PartSelect Number PS11746209

Manufacturer Part Number WP8536939

This insert is sold individually. Knob not included. Knob is sold separately.

Installation Instructions

Larry from HICKORY, NC

The main knob insert snapped.

Nothing to it. Just remember to put the insert in the knob, NOT on the selector stem. Line up the flat part of the insert with the flat part of the stem and push the knob in place.

Don NOT ram it on the selector stem. When it's seated, don't push any more. That's all there is to it. It works. If the pointer on the knob indicates the selector is lined up correctly, but it isn't, the problem is the selector, not the knob. Read more...

Videos!

Your Price

$11.09

Admiral Washer Control Knob

★★★★★

5 Reviews

PartSelect Number PS11757250

Manufacturer Part Number WPW10711289

This control knob is for dryers. Control knob lets you control cycle settings. Remove the knob by pulling it straight off its post.

Installation Instructions

JEFFREY from MODESTO, CA

The broke of the knob and had to replace the whole mother board and the knob

I had to remove the whole top of the washer and unplugged all the wire to the board. Getting the board out was the hardest thing to do because no screws it was clamped in place. Once I figured how to unclamped the thing without breaking it, it was relatively simple and to only 15 min to button it back up. Read more...

Your Price

$40.00

Admiral Washer Knob

★★★★★

2 Reviews

PartSelect Number PS11756281

Manufacturer Part Number WPW10558463

Your Price

$51.34

Admiral Washer Timer Knob

PartSelect Number PS10067044

Manufacturer Part Number W10756270

(4 Pack)

Installation Instructions

Mario from OXNARD, CA

Timer knob popped off. Base rod into knob snapped. Needed new timer

Removed back panel screws. Left/Right, Center.
Grabbed Canned Air and sprayed inside panel. Lots of lint ...
Unscrew timer - Single center top screw. Tiny threads, kind of wide head.
Unplug 4 wire adapters .. (top/left/right/bottom).
All 4 pin adapters have unique A/B side. Can't mix up.
Reconnect wires, tighten top center screw.
Before closing up panel, plug in test with empty tumble to confirm if dryer heats up. (Gas Dryer).
All good, has worked great. Read more...