Hotpoint Dishwasher Hardware

Your Price

$8.54

Hotpoint Dishwasher Screw 8-16 hxw 1/2 Stainless Steel

★★★★★

2 Reviews

PartSelect Number PS258461

Manufacturer Part Number WD02X10067

Sold Individually.

Fixes these symptoms

Noisy
Not cleaning dishes properly
See more...

Installation Instructions

Farhan from EL DORADO HLS, CA

Spray arm fell off and melted due to screw loss

1. Unscrew the nozzle part from the dish rack and pull it down from the clip side. 2. Replace the new nozzle by inserting the plain side in first and clip it in. 3. Tighten the screw. 4. Insert the spray arm hole in the nozzle and tighten the screw with washer. 5. Start washing dishes Read more...

Videos!

Your Price

$13.82

Hotpoint Dishwasher Push On Nut

★★★★★

7 Reviews

PartSelect Number PS298353

Manufacturer Part Number WR2X7054

This push on nut is for your dishwasher or refrigerator. As the name suggests, it pushes into place, rather than being screwed in. It is approximately half an inch in diameter and is made of stainless steel.

Fixes these symptoms

Leaking
See more...

Installation Instructions

Joseph from Livermore, CA

Water leak from gate (diverter) valve shaft

This was a fairly simple repair. After disconnecting power to the dishwasher and removing the panel below the door, first had to remove a retainer C clip from the gate valve shaft. Then disconnected the linkage from the gate valve solenoid, removed two return springs and slid the gate valve contol arm off the shaft. Then removed the solenoid bracket that was fastened to the housing by 2 screws. This allowed access to the push on nut on the valve shaft. Removed the old push on nut which exposed the leaking seal. Removed the bad seal, then moistened and carefully slid on and seated the new drain valve shaft seal. Affixed new push on nut. Reinstalled the above mentioned parts that were removed. Problem solved - no more leak. Total cost $18.81 for factory GE parts plus $6.95 shipping. Thank you PartSelect. Read more...

Your Price

$13.56

Hotpoint Dishwasher Hex Head Screw 10-32 GX HXW 3/8

★★★★★

1 Review

PartSelect Number PS8688150

Manufacturer Part Number WD02X10220

Your Price

$8.06

Hotpoint Dishwasher Screw - 8-18 B HXW .480 S

PartSelect Number PS2337849

Manufacturer Part Number WD02X10160

This is a genuine hex head screw replacement, designed for use with dishwashers. Most of this type of screw is used to hold the kickplate in place on the bottom of your appliance. This screw is sold individually, therefore you'll need to order the quantity you require. It measures 8-18 x .480.

Videos!