Hotpoint Microwave Latches

Your Price

$17.95

Hotpoint Microwave Door Latch

★★★★★

7 Reviews

PartSelect Number PS12725571

Manufacturer Part Number WB10X32782

Enhance the lifespan and optimal functioning of your GE microwave with our Door Latch, an exquisite addition for your appliance. This vital piece, meticulously designed by GE, maintains the security of your microwave, ensuring it remains closed during its operation cycle to provide effective performance and safety. Because of the potential high-voltage risks associated with microwaves, we strongly recommend this part is installed by a qualified service technician. Redefine the security of your appliance with this high-quality GE Door Latch, a part destined to keep your microwave in optimal condition for years to come.

Fixes these symptoms

Door not closing properly
See more...

Installation Instructions

Fernando from WEST CHESTER, PA

Mirowave door latch

While installing a filter in my brand new never been used microwave range hood combo I snapped off the top door latch with my elbow. After a few expletives I search You Tube and found it was a simple fix. I ordered a replacement latch from this site. It arrived in three days and it took 5 minutes to fix. Read more...

Your Price

$53.85

Hotpoint Microwave Door Latch Housing

★★★★★

10 Reviews

PartSelect Number PS1019899

Manufacturer Part Number WB06X10610

The door latch housing encloses the door switches and door latch.

Fixes these symptoms

Won’t turn on
See more...

Installation Instructions

Charles from CLAYTON, NJ

Tripping circuit breaker, broken micro switch locking pin

1. Unplug unit
2. Open door, remove two screws above the top trim piece, slide and remove trim.
3. Remove screw behind control board and top left corner, then release from position.
3b. Unplug all wire terminations and set control panel aside.
4. Remove two screws securing latch board, lift and rotate board out of position, remove three micro switches, xfer monitor switch actuator from lower pin in old board and insert in new. Install new door switches and reverse procedure to complete repair.

Note 1. Take care to located new latch board so holding tabs line up, pass through frame, and openings for door tangs line up with openings in frame before securing with screws.

Note 2. A long magnetic screwdriver is helpful. Read more...