01282 - Overview
Models starting with 01282
Click on the best match to narrow your results.
- 01282 Presto Pressure Cooker (Pressure Cooker)
- 01282-0 Briggs and Stratton Pressure Washer (Briggs & Stratton Pressure Washer Model 01282-0 (012820, 01282 0) Parts)
- 0128202 Presto Pressure Cooker (8-Quart Aluminum Pressure Cooker)
- 0128204 Presto Pressure Cooker (8-Quart Aluminum Pressure Cooker)
- 0128206 Presto Pressure Cooker (8 Quart Aluminum Pressure Cooker)
Keep searches simple, eg. "belt" or "pump".
Gasket for Pressure Cooker Interlock Assembly
PartSelect #: PS10468651
Manufacturer #: 85660
$3.99
In Stock
Filter A/C Cartridge
PartSelect #: PS8987387
Manufacturer #: 491588S
This is a replacement air filter/AC cartridge for your small engine. The air filter prevents dirt and debris from entering the engine. Over time, the air filter can become clogged or damaged, and this...
$7.06
In Stock
Lawn Mower Spark Plug
PartSelect #: PS9140427
Manufacturer #: 796112S
This part is the replacement spark plug for your engine. It measures approximately 2.5 inches by 1 inch. The spark plug creates the spark that ignites fuel in your engine during the combustion process...
$4.99
In Stock
Lawn Mower Carburetor Overhaul Kit
PartSelect #: PS8984098
Manufacturer #: 498260
This is a replacement carburetor overhaul kit for your small engine. The carburetor is essential to the overall performance of your engine, and the carb can get clogged up over time for a variety of r...
$17.96
In Stock
Lawn Mower Air Cleaner Gasket
PartSelect #: PS9138757
Manufacturer #: 795629
The Air Cleaner Gasket is used to provide a seal between the air cleaner base, and carburetor. It's a gray, composite material part, which is rated as "Easy" to install and will require a screw driver...
$5.19
In Stock
Engine Ratchet Pawl
PartSelect #: PS8942598
Manufacturer #: 281505S
The manufacturer-approved Ratchet Pawl (Starter Pawl) comes in a set of two (2). This part attaches inside the recoil assembly, and is used to engage the flywheel. if broken due to wear/damage it will...
$3.99
In Stock
Engine Float Valve Kit
PartSelect #: PS8963322
Manufacturer #: 398188
This needle and seat kit, also known as a float valve, is found in many types of liquid-fueled lawn equipment, such as carburetors. The valve regulates the flow of fuel into the float bowl. The needle...
$6.97
In Stock
Common Symptoms of models starting with 01282
[Viewing 3 of 3]Will Not Start
Fixed by
these parts
these parts
Show All
Engine will not idle
Fixed by
these parts
these parts
Show All
Cannot pull starter cord out or engine will not turn over
Fixed by
these parts
these parts
Show All
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
starter rewind cord broke
I found the model number of the Briggs & Stratton engine on the inside of the engine housing. Ordered a new starter-rewind unit, as the old cord broke and the thing was well worn. The instructions were clear enough, but to get the old starter off I had to drill out four rivets, which just spin around when you try. I used a hacksaw, chisel
... Read more
, pliers, whatever worked on each rivet; this took a while. When they were finally removed, the new starter pull unit was relatively easy to install with the small nuts and bolts provided. On the Yard Machines log splitter, putting back the engine housing is quite tricky; you have to jostle the thing into place, get the pull handle above the cover and line up the bolt holes.
Read less
Parts Used:
-
Seikai from MARICOPA, CA
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:1- 2 hours
-
Tools:Nutdriver, Pliers, Screw drivers, Socket set, Wrench (Adjustable), Wrench set
14 of 20 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Mower body was die cast and in good condition. Engine was burning oil.
Removed engine, no specialty tools required. Honed the cylinder, and lapped the valves. Tip on compressing valve spring for reassembly; compress springs with you finger and tie them with 2 zip ties, cut the zip ties after installing the keepers. Repainted the mower deck and engine. It runs and looks like new. My Toro is a 1999 model .
Parts Used:
-
Robert from TEGA CAY, SC
-
Difficulty Level:Really Easy
-
Total Repair Time:More than 2 hours
5 of 7 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Replace carburetor
Loosened engine cover and moved out of the way
Removed air intake and filter
Loosened and disconnected gas line to carburetor
Unscrewed carburetor and disconnected from throttle arm
Reversed process using new carburetor, O-ring and gasket
Removed air intake and filter
Loosened and disconnected gas line to carburetor
Unscrewed carburetor and disconnected from throttle arm
Reversed process using new carburetor, O-ring and gasket
Parts Used:
-
David from KNOXVILLE, TN
-
Difficulty Level:Really Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Pliers, Screw drivers, Socket set
8 of 18 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!