020290-0 Briggs and Stratton Pressure Washer - Instructions
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
The copper fitting on the chemical injection broke.
I order the part from this site and received it within a week. the only problem was that spring was missing out of the sealed bag. NO PROBLEM!!! I cut a ball point pen spring to fit and everything works just fine. You just have to remember to put the spring in first, then the ball bearing and then the rubber o-ring.If you put them in backwards you pressure will fed directly into your chemical container!!
Parts Used:
-
Carl from ARCADIA, FL
-
Difficulty Level:Very Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Nutdriver, Screw drivers, Socket set, Wrench (Adjustable), Wrench set
12 of 17 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Factory Manifold plug eroded and broke loose
Using a flat head screw driver remove what's remaining of the old plug. Install the new plug, making sure you do not tilt the machine too much or it will size up.
Parts Used:
-
Greg from NEW KENSINGTN, PA
-
Difficulty Level:Very Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Wrench set
1 person
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!