1130SWE Cub Cadet Snow Blower - Overview
Models starting with 1130SWE
Click on the best match to narrow your results.
Keep searches simple, eg. "belt" or "pump".
Snow Blower Carriage Bolt
PartSelect #: PS10001568
Manufacturer #: 710-0451
This carriage bolt measures 5/16-18 x .75 and fastens two parts in your machine together. It has a round domed head and a square underside so the bolt does not rotate once it has been secured into pla...
$5.19
Special Order
Snow Blower Shear Bolt
PartSelect #: PS10001820
Manufacturer #: 710-0890A
This is a shear bolt, also known as a snap-off bolt. This is a fastener designed to break under a specific amount of pressure and protect the machine it is installed on from that excessive load. In la...
$4.13
In Stock
Snow Blower Chute Flange Keeper
PartSelect #: PS10005747
Manufacturer #: 731-0851A
This chute flange keeper is sourced from the original equipment manufacturer for use in snowblowers. The plastic keeper allows the snowblower chute to pivot, and secures the flange that connects the c...
$6.15
Special Order
Snow Blower Hex Flange Bearing
PartSelect #: PS9178250
Manufacturer #: 941-0245
Used mainly in snow blowers, this flange bearing is typically installed on the axle and creates a tight fit with little friction while still allowing for movement.?Your equipment will likely feature m...
$9.45
In Stock
Snow Blower Worm Gear
PartSelect #: PS9165943
Manufacturer #: 917-04861
This is a worm gear that is designed for use within a variety of snowblowers and snowblower tractor attachments. The worm gear is used to rotate the auger through the drive mechanism, also known as th...
$44.19
In Stock
Snow Blower Washer
PartSelect #: PS10006541
Manufacturer #: 736-0242
Sourced directly from the original manufacturer, this Bell Washer is made of gold-colored metal and is sold individually, not as part of a kit or assembly. It is used to provide spacing between variou...
$5.35
Special Order
Lawn Mower Washer
PartSelect #: PS9311087
Manufacturer #: 936-0119
This Washer-Lock 5/16 is a silver, metal part that is sold individually and comes direct from the manufacturer. With a 5/16 Inch Interior Diameter and 1/2 Inch Outside Diameter, it is used to prevent ...
$5.12
In Stock
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Original shave plate badly worn
With WD-40 or equivalent, spray the four nuts on the underside of the snow blower housing that hold the shave plate to the housing. Also spray the two bolts that hold the shave plate to the side of the housing. Let sit for a few minutes and using a 1/2" box end wrench remove the four nuts on the bottom of the housing. If necessary, app
... Read more
ly heat with a torch to loosen. Using a 9/16" box end wrench, remove the nuts on the sides (these also hold the adjustable skid feet). It is recommended that the bottom bolts and nuts be replaced with 5/16-18 X 3/4" long zinc plated carriage bolts using zinc plated washers and ny-lock nuts. It is also recommended that all of th screw threads be coated with an anti- seize lubricant so disassembly at a later date will be easy.
Read less
Parts Used:
-
John from HARRISVILLE, NH
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Wrench set
5 of 16 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!