1153 - Instructions

Unfortunately I couldn’t find the spacer on the Internet, so I ended up going to the hardware store and buying multiple sizes of spacers and bearings to complete the install. I ended up using a steel spacer with shoulder and two bearings. Way overkill, but worth the three dollars.

First I watched the Parts Select video (Dishwasher Control Panel (Part #00475255 - How to replace) on YouTube just to be sure I could do the replacement. I ordered the part (delivered next day) and replaced the control panel in less than 30 minutes while watching the video. One note, you should be prepared to have a small stool or box to set the electrical components on while swapping the buttons on the control panel. I did not want to leave them hanging by the wires and this is not shown on the video.

With WD-40 or equivalent, spray the four nuts on the underside of the snow blower housing that hold the shave plate to the housing. Also spray the two bolts that hold the shave plate to the side of the housing. Let sit for a few minutes and using a 1/2" box end wrench remove the four nuts on the bottom of the housing. If necessary, apply heat with a torch to loosen. Using a 9/16" box end wrench, remove the nuts on the sides (these also hold the adjustable skid feet). It is recommended that the bottom bolts and nuts be replaced with 5/16-18 X 3/4" long zinc plated carriage bolts using zinc plated washers and ny-lock nuts. It is also recommended that all of th screw threads be coated with an anti- seize lubricant so disassembly at a later date will be easy.

Placed on stands to hold mower up, then removed wheels and clips, then placed new axle in place and replaced clips and wheels.