120P - Overview
Models starting with 120P
Click on the best match to narrow your results.
Keep searches simple, eg. "belt" or "pump".
Engine Crankcase Gasket
PartSelect #: PS9066140
Manufacturer #: 692232
This part is the replacement gasket for the crankcase on your engine. The gasket helps to create a seal on the crankcase and prevent leaks. If you notice that your engine is not running at peak perfor...
$6.39
Special Order
Engine Oil Seal
PartSelect #: PS8948679
Manufacturer #: 299819S
This OEM Oil Seal is an individually sold rubber part which is attached around the axis shaft on the crankcase housing to provide a proper seal. A broken seal will lead to a leak, and the part should ...
$5.99
In Stock
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Bought Troy Built pressure Washer at garage Sale for $30.00 leaked fuel
I have a solid understanding of small engines. This pressure washer was used twice in 2013, when purchased. Sat in a garage for a couple of years with gas in tank and carburetor. Owner was moving and after 7 years of moving it around he sold it at a garage sale.
I took it home and took off gas tank and thoroughly cleaned it. Then we ... Read more nt through the carburetor and let soak in cleaner. Cleaned up the spark plug, tested and has good spark. reinstalled carburetor but would not start. I knew I had gas issues. I ordered a carburetor kit and replace the needle valve and seals. Still would not start. Ordered a new carburetor and spark plug. Installed both. Two pulls and it runs like new. Advice: don't try to clean out old carburetor, just buy a new one and install.
I took it home and took off gas tank and thoroughly cleaned it. Then we ... Read more nt through the carburetor and let soak in cleaner. Cleaned up the spark plug, tested and has good spark. reinstalled carburetor but would not start. I knew I had gas issues. I ordered a carburetor kit and replace the needle valve and seals. Still would not start. Ordered a new carburetor and spark plug. Installed both. Two pulls and it runs like new. Advice: don't try to clean out old carburetor, just buy a new one and install.
Read less
Parts Used:
-
Laird from North Las Vegas, NV
-
Difficulty Level:Difficult
-
Total Repair Time:More than 2 hours
-
Tools:Nutdriver, Pliers, Screw drivers, Socket set
2 of 3 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Screw in new dipstick, check oil level
-
Kim from KENNER, LA
-
Difficulty Level:Very Easy
-
Total Repair Time:Less than 15 mins
3 of 10 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!