Models > 2254XPA > Instructions

2254XPA (GTH 954571229 -2004-08) Husqvarna Lawn Tractor - Instructions

All Instructions for the 2254XPA

Wheel bushings were bad

Removed old clip removed rim from tractor, removed grease fitting on rim, took hammer and screw driver knocked out old bushing turned rim over knocked out other bushing. Press in new bushings reinstalled grease fitting slide tire back on tractor, put retaining washers on then locking clip put on dust cover grease at grease fitting. Repeat other side.

Parts Used:

Lawn Mower Ring Clip

Lawn Mower Axle Hub Cap

Anthony from OLIVEHILL, TN
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Screw drivers

22 of 36 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Worn out Mandrel Assemblies

Remove Deck, Remove Blades, Remove guards and belt, use old belt to hold pully to remove pully (would be good to have pully wrench), Remove mandrel Assembly, Install new mandrel assemblies (had to tap the new mandrel assemblies. Should have been done by manufacturer.). Reinstall blades, guards, and belt. Put deck back on.

Parts Used:

Lawn Mower Mandrel Assembly

Joseph from CANBY, MN
Difficulty Level:
Difficult
Total Repair Time:
More than 2 hours
Tools:
Socket set

2 of 3 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Deflector shield cracked. Need to replace.

Mark the location of the spring so you know how it goes on. Snip off the push nut holding the deflector shield pin. Hammer the pin out. Insert the pin with the spring holding the new deflector shield. Use a socket to steady the push nut and hammer the pin into the push net until secure.

Parts Used: