325LX (20000100001-20020100000) Husqvarna Edger - Instructions
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Fixed up somebody's old trimmer they threw at the curb
This trimmer was in relatively good shape. Somebody had thrown it out! They thought they had broke the rewind, but when I ended up taking it off, it sucked right back in. They also must have broke the vibration plate on the bottom. With the screws and plate I bought from here, plus a new head and service kit I got elsewhere , this thing ran like a champion again.
Parts Used:
-
Jeremy from DILLSBURG, PA
-
Difficulty Level:Easy
-
Total Repair Time:15 - 30 mins
5 of 10 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Take the wheel off. Place the key in the slot. Put the wheel back on.
-
Gary from PILESGROVE, NJ
-
Difficulty Level:Very Easy
-
Total Repair Time:Less than 15 mins
5 of 11 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Broken deck belt
replaced with new Kevlar belt following threading guide diagram on deck. Only had to loosen several small screws to remove protective shield to allow space for threading new belt onto pulleys.
Parts Used:
-
Jim from KENNEWICK, WA
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
2 of 3 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Dryer runs no heat
Disassemble dryer. Replaced element assembly. Re assembled dryer. Unit runs and heats.
Parts Used:
-
Russell from MACON, GA
-
Difficulty Level:Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers
1 of 3 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Front wheels, too much end play
-
Frederick from BINGHAMTON, NY
-
Difficulty Level:Very Easy
-
Total Repair Time:Less than 15 mins
10 of 35 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
part not same
Ordered on/off switch. My switch had only one wire terminal. Replacement had two. I ran a wire from one to a screw as a ground. Switch worked fine.
Parts Used:
-
Bruce from ALGOMA, WI
-
Difficulty Level:Easy
-
Total Repair Time:15 - 30 mins
4 of 18 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!