Your coupon for will be reflected when you check out!
✖
Your coupon for
✖
Hello!
You're visiting the PartSelect site in U.S.
Would you like to shop on the Canadian site?
Stay on this site
Go to Canadian site
✖
Model Number Locations
1Select Category Type
Select Category Type
2Select Product Type
Select Product Type
3Select {MODEL} Type
Select {MODEL} Type
Sample Model Number Tags
Model numbers can be made up of numbers (1005400, for example) or a combination of letters and numbers (LAT1000AAE). The model number will most likely appear on either a paper sticker or a metal plate. Your appliance's model number tag may look similar to the sample model number tags shown here (model number highlighted in yellow):
Model has been saved to My Models. If you're not signed in, your lists are available on this device and will expire within 30 days.
Model has been saved to My Models.
This bin temperature sensor is for ice makers.
The bin temperature sensor monitors the temperature in the ice maker bin and sends the temperature reading to the electronic control board.
Disconn...
This ice maker scoop is an OEM refrigerator part designed to retrieve ice from the ice maker bin. It is made of plastic and measures approximately 10 3/4 inches in length and 4 inches in width. The sc...
Introducing the genuine OEM Tube Water Inlet, an essential component designed to enhance the performance of your appliance. Carefully crafted by Whirlpool, this reliable part fits into a selection of ...
Introducing this genuine OEM Drain Cap by Whirlpool. This component is specifically designed for compatibility with a selective array of Whirlpool, KitchenAid, Maytag, Jenn-Air, Amana, Inglis, and Mag...
Part Number W10919199 is an OEM part for Whirlpool ice machines. It is responsible for slicing the ice into uniform cubes after the ice has formed in the ice maker's mold. If your ice cubes are irregu...
This genuine OEM Electronic Control Board is a vital component for Whirlpool ice makers. This part masterfully oversees crucial ice maker operations such as freezing a slab of ice, slicing it effectiv...
I'm an hvac/r technician, and regularly work on ice machines. Begin my pulling the white over beneath the control panel. It snaps in place so pull on the bottom then left out. 1/4 nut driver is all you need, and remove the screw holding the bin thermistor clip to the side. Up to the right , beneath the control panel, behind the plasti
... Read morec panel you previously removed is the mollex connector. Unplug the thermistor and follow instructions in reverse to reinstall.
removed the front cover below the compartment door,removed the 2 screws holding the valve to the case and removed the water lines from the valve.The process was reversed to install the new valve.
Pull cover off in front of ice tray and ice grid cutter to make easy to get at temperature sensor wire connector. remove connection plug to temperature sensor remove screw on side of ice bin that holds sensor in position. Put sensor in a class of ice 32 degrees and measured resistance read 6.2K should of been read 8.7K Ordered a
... Read more new Temperature sensor from partselect.com . Installed in 5 min working like a champ again. The instructions book call the part I need a Bin Thermister instead off temperature sensor.
