967003903 Husqvarna Lawn Mower - Overview
Sections of the 967003903
[Viewing 1 of 1]
Keep searches simple, eg. "belt" or "pump".
Lawn Mower Hex Head Bolt
PartSelect #: PS9982804
Manufacturer #: 584953901
This part is the replacement washer head screw for your lawn tractor. It is black in color and is approximately an inch and a half in length. This self-threading screw is most commonly used for securi...
$3.99
In Stock
Lawn Mower Blade Bolt and Washer Assembly
PartSelect #: PS9020856
Manufacturer #: 532193003
This manufacturer-approved bolt and washer assembly is for lawn tractors.
Wear work gloves to protect your hands when installing this part.
$9.62
In Stock
Lawn Mower Mandrel Assembly
PartSelect #: PS12116539
Manufacturer #: 587820301
This mandrel assembly is for lawn tractors.
Mandrel assembly attaches to the mower deck and spins the blades. The assembly may include multiple parts; refer to your parts diagram for a complete lis...
$58.37
In Stock
Lawn Mower Push Nut
PartSelect #: PS9285696
Manufacturer #: 532110452
The Push Nut is a black, metal nut, which can be installed with pliers and a hammer. It's used to secure parts in place in various locations on a variety of equipment. If damaged will not longer hold ...
$3.99
In Stock
Lawn Mower Interlock (Clutch) Switch
PartSelect #: PS9288217
Manufacturer #: 539101080
$20.68
Special Order
Questions And Answers for 967003903
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Worn out Mandrel Assemblies
Remove Deck, Remove Blades, Remove guards and belt, use old belt to hold pully to remove pully (would be good to have pully wrench), Remove mandrel Assembly, Install new mandrel assemblies (had to tap the new mandrel assemblies. Should have been done by manufacturer.). Reinstall blades, guards, and belt. Put deck back on.
Parts Used:
-
Joseph from CANBY, MN
-
Difficulty Level:Difficult
-
Total Repair Time:More than 2 hours
-
Tools:Socket set
2 of 3 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Deflector shield cracked. Need to replace.
Mark the location of the spring so you know how it goes on. Snip off the push nut holding the deflector shield pin. Hammer the pin out. Insert the pin with the spring holding the new deflector shield. Use a socket to steady the push nut and hammer the pin into the push net until secure.
Parts Used:
-
Travis from PLATTE CITY, MO
-
Difficulty Level:Really Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Socket set
3 of 8 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!