Your coupon for will be reflected when you check out!
✖
Your coupon for
✖
Hello!
You're visiting the PartSelect site in U.S.
Would you like to shop on the Canadian site?
Stay on this site
Go to Canadian site
✖
Model Number Locations
1Select Category Type
Select Category Type
2Select Product Type
Select Product Type
3Select {MODEL} Type
Select {MODEL} Type
Sample Model Number Tags
Model numbers can be made up of numbers (1005400, for example) or a combination of letters and numbers (LAT1000AAE). The model number will most likely appear on either a paper sticker or a metal plate. Your appliance's model number tag may look similar to the sample model number tags shown here (model number highlighted in yellow):
Model has been saved to My Models. If you're not signed in, your lists are available on this device and will expire within 30 days.
Model has been saved to My Models.
This bake element kit has two slip on connecters at the rear end and is located at the bottom of the oven.*Please note: this part has been updated by the manufacturer and no longer has a terminal bloc...
Enhance your kitchen?s aesthetic with this stylish Samsung Door Epicure Hinge. This high-quality replacement part is crafted to meet Samsung's stringent specifications, ensuring it seamlessly fits you...
I did not do the repair since the part shipped was not the correct one. I have contacted Customer Service by phone and mail and nothing has been resolved.
I would, at least, like to return the incorrect part. An new one would be great but not holding out hope.
First disconnected power to the oven at circuit breaker box. Then, Removed top front control panel, held by four screws exposed when top oven door is opened. Was able to move control up and out of the way without disconnecting. The relay control panel is visible on the right. I was able to reach all connectors with needle nose plie
... Read morers and then remove the panel with needle nose to release clips and use screw driver to gentle pry up. Installed new unit by attaching back connectors and then setting panel down onto clips. Finished with attaching front connectors. Reattach front control panel.
