This oven rack is chrome in color and is approximately 24.76 inches wide by 15.78 inches deep. If your old oven rack is damaged, you should consider replacing it. Many of our customers have determined...
$84.80
In Stock
Order within the next 5 hrs and your part ships today!
This is a multi-use and multi-appliance screw. It can be used on a microwave, refrigerator, range/oven, air conditioner, dehumidifier, washer, or dryer. The measurements of this screw are 8 x 1/2 inch...
$20.77
In Stock
Order within the next 5 hrs and your part ships today!
The temperature sensor measures the temperature inside the oven. If your oven is too hot, not heating evenly, is not heating enough when baking, or simply will not start, you could have a faulty tempe...
$89.89
In Stock
Order within the next 5 hrs and your part ships today!
This broil element is found on the roof of the oven. The broil element is at the top of the oven and supplies the heat to broiling. 14" x 15" with 1-3/8" inserts.
This part works with the following...
$150.44
In Stock
Order within the next 5 hrs and your part ships today!
This part is for oven ranges, it connects individual wires and protects the device from electrical surges, voltages, and current. With this part, the house power is connected to the range wire harness...
$34.05
In Stock
Order within the next 5 hrs and your part ships today!
This touch-up paint can be used on a wide variety of household appliances. It is most often used on washers, dryer, refrigerators, dishwashers, ranges, freezers, trash compactors, or microwaves. It is...
$8.00
In Stock
Order within the next 5 hrs and your part ships today!
This thermostat is also known as a thermal cut-off fuse and is used in conjunction with your range. This part establishes and maintains the internal temperature of the oven cavity. When the temperatur...
$66.80
In Stock
Order within the next 5 hrs and your part ships today!
This part is a light bulb that is 120-130 volts and 15 watts, and is used in conjunction with your range or wall oven. The function of this bulb is to illuminate the interior of the oven.Before making...
$47.56
In Stock
Order within the next 5 hrs and your part ships today!
This is the replacement large surface element for your cooktop or range. It is approximately 10-inches in diameter and is 1200/2500 watts. The large surface element is installed under the cooktop and ...
$149.58
In Stock
Order within the next 5 hrs and your part ships today!
Order within the next 5 hrs and your part ships today!
Questions And Answers for KESS907SSS04
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
6 questions answered by our experts.
Sort by:
< Prev
1
2
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Scott
September 12, 2022
Left front burner eye red 'on light' flickers when on and eye comes on very hot even when turned to med or low then recedes to low or off. Temp level very erratic regardless of temp selected. Is eye burning out or temp control an issue? other?
For model number KESS907SSS04
Hello Scott, thank you for reaching out. According to our research on the model, the problem appears to be with the Range Surface Element Control Switch, part number PS11747407. Customer service is available 7 days a week if you need help placing an order. We hope this helps!
Good morning!!!! I have this Electric Range Model and I need to change it, but I am not sure if is Freestanding Range or a Slide in range. How could I differenciate each of those. Thanks in advance for your help!!!
For model number KESS907SSS04
Hello Ana, thank you for contacting us. Your model is a slide-in range. Freestanding ranges feature a backguard with oven controls, burner controls, or both, whereas slide-in ranges display controls that are located on the front of the range or the cooktop surface. Glad to be of assistance!
1 person found this helpful.
Was this helpful?
Thank you for voting!
Kevin
October 13, 2022
Oven runs away with temperature. Display usually says preheating but doesn't reach displayed temp even though separate grill probe keeps climbing on the temp. No errors on display. Ohms reading on probe is 1087 at room temp. Looking for suggestions.
For model number KESS907SSS04
Hello Kevin, thank you for contacting us. We would recommend checking the following parts to fix your issue: Temperature Sensor, part number PS11748765, High Limit Thermostat, part number PS11747248, and Broil Element, part number PS11747304. We hope this helps! If you need help placing an order, customer service is open 7 days a week. Thanks again for your great question.
What parts would I need if the range works fine but the oven control pad does not work, it’s won’t respond to touch it’s like it’s powered off. Thx
For model number KESS907SSS04
Hello James, thank you for getting in touch. We have concluded that the issue is with the control board, part number PS11749720. You may need to check it to solve the problem. Glad to be of assistance!
Takes almost an hour to preheat oven to 350 degrees. What could be the problem and/or how do i troubleshoot?
For model number KESS907SSS04
Hello and thank you for writing.
It certainly sounds like it could be a faulty high limit thermostat PS11747248 and/or possibly a faulty temperature sensor PS11748765, you should check the part(s) for signs of damage, and replace as necessary. We hope this helps. Please contact us anytime if you require further assistance.
Something Kitchen Aid wont tell you but running a self clean on this model stove blows the fuse located on the back of the stove.
First I slid the stove out and removed the back of the stove held in place by 8 Phillips screws. The thermostat fuse is located near the top middle on the back of the stove. Remove the 2 screws hold
... Read moreing it in place. Disconnect the wires, plug in the new part. Put it all back together. Job done in less than 30 minutes.
This repair would have cost $164 through A&E factory service.