This sensor cover, also known as the ice maker thermostat cover, is a genuine OEM replacement part for Samsung refrigerators. It is made of durable white plastic and has measurements of approximately ...
This is a refrigerator ice dispenser lever. It is clear and made entirely out of plastic. The function of the ice dispenser lever is to dispense ice when the lever is pushed. If the lever is cracked o...
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
1 question answered by our experts.
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Randy
October 21, 2021
My Samsung never turns off, the fridge part is freezing everything. Had repair company replace evaporator about a year ago. After that its always been noisy.
For model number RS269LARS
Hello Randy, Thank you for the question. If the refrigerator runs constantly there might be something caught in the condenser fan motor blade, or the condenser fan motor might be defective. We hope this helps!
Removed 2 screws, popped out the old part. Looked at the part number on the piece. Ordered and when it arrived 3 days later, I put the new part in its place. Works great.
Replaced the Broken Cover Motor and the Fan Blade. Fan motor was test with 12VDC power supply, or by replugging fan connector and holding down the door closing switch.
After a few days, the fan made loud noise. Due to defrog heater was open when it was test with ohmmeter. Ice deposited around the fan.
I had to buy
... Read more a whole ASSY EVAP-REF part # DA96-00395C, and seperated the evaperator, and replaced the heater and sensor. Spray bottle was used spray hot water to de-iced the evaperator. And salt accelerated the ice melting process.
Note: spray water to clean salt before installing new parts
Using the putty knife, pry off the faceplate for the ice/water dispenser. Disconnect the wire harness. Using philips head screwdriver, remove the dispenser assembly. Remove the old dispenser and replace. Reverse for reassembly. Note * I should have bought the water dispenser lever and replaced it as well since I had the assembly out.
... Read more Secondary note * be mindful during reassembly to not put pressure on the water dispenser or have a glass handy. :)