Parts That Fix Whirlpool Refrigerator WRF532SMHZ01 Door won’t open or close
This is a replacement pivot block for your refrigerator. It is made of white plastic and is approximately 4 inches long and 1 inch wide. The pivot block catches and holds the door mullion cover when you close the door. If your refrigerator door will not close properly, you may need to replace the pivot block. This part is sold individually and is an OEM part sourced directly from the manufacturer.
Replacing your Whirlpool Refrigerator Refrigerator Pivot Block
Customer Repair Stories
-
Jan from Boca Raton, FL
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers
-
Daniel from CENTREVILLE, MD
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers
This is a center crisper rail for your refrigerator. This part acts as a support rail for the crisper drawer by holding the center of the crisper frame. You will need to replace this part is if your current drawer is not opening or closing properly. This crisper rail is white and it is made entirely of plastic. It is roughly 13.5 inches long, and 2.5 inches wide. This is an easy repair which requires no tools.
Replacing your Kenmore Refrigerator Refrigerator Center Crisper Rail (White)
Customer Repair Stories
-
albert from quakertown, PA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Ruth from Roxbury, MA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
This door gasket is used to seal the refrigerator door when closed to keep the cool air inside and the room air out.
Customer Repair Stories
-
Chet from TOLEDO, OH
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Joel from DELRAY BEACH, FL
-
Difficulty Level:Very Easy
-
Total Repair Time:Less than 15 mins
These parts will attach to your drawer rail and are used to help the drawer glide smoothly.
Replacing your Whirlpool Refrigerator Drawer Gear Kit
Customer Repair Stories
-
Craig from Kingsport, TN
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Nutdriver, Screw drivers
-
Megan from NORFOLK, VA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
The vertical mullion rail with a built-in mullion heater creates a tight seal between the doors of a French-door refrigerator. This helps prevent air leaks and excess moisture buildup. If you notice condensation or an improper door seal, replacing the mullion rail can help restore efficiency. Always disconnect power before installation and ensure compatibility with your model.
Customer Repair Stories
- Remove the screw from the center hinged cover.
- Remove the mullion rail by pushing upward. The top and bottom hinges slide over tabs attached to the door. I had to bump it gently from underneath.
- Disconnect the three wire connector that's underneath the center hinged cover.
... Read more
Install the new mullion rail by reversing the above steps:
- Connect the three wire connector and snap it into its holder.
- Slide the new part over the top and bottom hinges. Be sure that all three hinges are correctly lined up before sliding the rail over the tabs.
- Push it down far enough that the hole for the screw in the center cover is lined up with its corresponding receptacle in the door.
- Replace the screw.
-
Michael from FALLBROOK, CA
-
Difficulty Level:Very Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Nutdriver
This is an OEM front cover for the pantry door of various refrigerator models. This cover is designed as a door that can cover the pantry compartment within your refrigerator and provide a transparent view of what is inside it. If this door is cracked, moldy, or missing, it needs to be replaced. This pantry door is made of durable white plastic and features a transparent window in the middle. This measures approximately 26 inches wide and 6 inches deep, and can be replaced by simply dislodging its securing tabs on the left and right side, and then inserting the new one into those same tabs. This pantry drawer cover is sold individually.
Customer Repair Stories
-
Linda from LOVINGTON, NM
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Snap In
Yes That Easy!!
-
T.W. from GREENWEL SPGS, LA
-
Difficulty Level:Very Easy
-
Total Repair Time:Less than 15 mins
This part helps with the closing of the door.
Replacing your Whirlpool Refrigerator Refrigerator Door Closer (Apollo Gray)
This crisper drawer cover support is for refrigerators. Crisper drawer cover support supports the crisper drawer lid. Wear work gloves to protect your hands when installing this part.
Replacing your Whirlpool Refrigerator Refrigerator Ladder Hook
Customer Repair Stories
-
Moises from Trenton, NJ
-
Difficulty Level:Very Easy
-
Total Repair Time:Less than 15 mins
-
Michael from Bedford, NH
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Customer Repair Stories
-
Ronald from WESTERVILLE, OH
-
Difficulty Level:Really Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Nutdriver, Screw drivers
Mounting screws not included.
Customer Repair Stories
-
Ken from LK HAVASU CTY, AZ
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers
-
Mary Sue from Tinley Park, IL
-
Difficulty Level:Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers
This mounting screw is a genuine OEM replacement part for the door handle in your refrigerator. If you are having trouble shutting the refrigerator door, or opening it, replacing this screw can help solve the issue. Replacing this part is easy and requires minimal disassembly of the refrigerator end cap handle. Your will need a screwdriver to complete this repair.