We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
2 questions answered by our experts.
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
John
March 1, 2023
Washer isn't fully spinning out and sometimes the spin will not engage at all doesn't make strange sounds just doesn't spin out will a new drive motor fix this issue
For model number Gtx680bsj6ws
Hi John, thank you for contacting us. According to our research, we recommend checking the speed sensor, part number PS16619248. You can check the continuity of this sensor with the multimeter. If this is fine, we suggest inspecting the clutch, part number PS11729473. If this is bad or broken, replace it. If the issue remains, you may need to replace the drive motor, part number PS11763333. Thank you for your inquiry, good luck with this repair!
Having spin issues. Motor starts spinning but stops at exactly 5 seconds. Tried the spin test via diagnostics and does the same thing. Already replaced speed sensor but still doing the same. Wondering if overload switch on motor is tripping or if motor is bad. Any suggestions? Thanks. The error code I got said that if motherboard doesn't see a signal from speed sensor it will stop after 5 seconds, but sensor is now new and was getting a signal on the connector on the motherboard side using a multimeter. I checked resistance on motor windins via red and yellow wire and got 5.5 Ohms, schematic on washer says it should be 3.1ohms.
For model number GTW485ASJ2WS
Hello Hector, thank you for reaching out. Based on the description that you have provided, we would recommend replacing the control board, part number PS17626552, to fix the issue. We hope this sorts out your problem!