Dual Radiant Element - 9 Inch WB30T10133

Hello Thomas, thank you for your question. Usually if the element is not working at all, inner or outer ring, the issue is the element itself. The switch regulates the temp, so if the switch is the issue usually the element turns on, but can't be regulated. Also, when the hot surface light remains on, this is a good indicator that the element is bad. I would recommend replacing the element itself. I hope this helps!

Hello Catherine, thank you for your question. The element itself probably has to be replaced. However, the issue could be the switch that controls that burner as well. We would recommend resting the switch first to be sure that isn't the issue. Here is a link that will show you how to test that switch. https://www.partselect.com/Range-Stove-Oven+Infinite-Switch-Testing+repair.htm I hope this helps!

Hello Ngovkim, thank you for writing. This 9" Dual Radiant Element is the replacement you are looking for on your model. To place an order, please feel free to contact customer service by phone or you may do so online. Thank you.

Hi Phil, please watch our video here: https://www.youtube.com/watch?v=_kPOgh3lX_Q. Thank you for your question and good luck with your repair!

Hi Matt, this part PS2321567 is the right replacement part according to the manufacturing. I would make sure you ordered the right part number. Thank you for your question and good luck with your repair!

Hello Paul, thank you for your question. I believe the model number is JP989T D 5WW. We were unable to find the model number you have provided. For the JP989T D 5WW model the front right element is PartSelect Number PS1154945 and the front left element and bridge (element that bridges the front left and back left burners is PartSelect Number PS955015. I hope this helps.

Hi Grady, Thank you for your question. Before beginning, make sure the circuit breaker is off. You will need to remove the cooktop from the counter. To do this you will need to go underneath and see what kind of brackets are holding it in place. The brackets will vary depending on the make and model and type of countertop is it laying on. These brackets will need to be removed. Here is some information that a customer has left as to how they removed/installed the switch that may be helpful to you as well, "Turned off power to counter top range and pulled-up from counter. Set range on counter and removed 16 screws from around the housing allowing me to pull-up and remove range top. Used socket to remove 4 screws holding control switch bracket in place and 2 screws holding bad switch in place. Disconnect wires from bad switch and reconnected to new switch. Placed and screwed switch bracket back in place. Before placing range top back I turned power back on to to test burner operation. Burner and switch operated correctly and I completed screwing range top back in place, setting back down into counter top. Done" Also, here is a link to a video that may help. It is not the same appliance but same basic steps for the switch. Hope this helps! https://www.youtube.com/watch?v=7hoJqv_pQvg. I hope this helps. Thank you and have a great day!

Hello Hyunjun, thank you for writing. Yes, this is the replacement for your model and may fix the problem. The correct Infinite Switch for it is part PS1481076. We hope this helps.

Hello Emily, thank you for inquiring. You will want to replace either this 9" Dual Radiant Element part number PS2321567 for your model if it is the burner not working correctly, or the 9" Surface Burner Switch part number PS1765835. I hope this helps and good luck with your repair!

Hi Steve, thank you for your question. Yes the part number you have provided is the correct part to fix your issue. We hope this helps.