Turbidity Sensor 154762601

Hi Era, Thank you for your question. Before you begin any repair please unplug the appliance from the electrical outlet and turn off the dishwasher's water supply. The turbidity sensor is mounted on the sump and tells the control board how dirty the water is so it can adjust the cycles. You will need to pull the dishwasher out to do the repair. You will need to disconnect the lines. First you will need to remove the dishwasher drain line. Have towel handy in case any water comes out. You will also need to remove the fill line attached to the hot water tap. Once you have this done, you can open the dishwasher door and take the bottom rack out. Then remove the screws that the dishwasher to the countertop. Once the screws are removed, You can pull the dishwasher out of the cabinet and lay it down on its back. Be sure to lay a blanket or towel down before you lay it down in case any water comes out of the dishwasher. Once the dishwasher is on it's back, you will now have access to the bottom of the dishwasher and the turbidity sensor. It is mounted on the sump just under the drain pump. Remove the wiring harness attached to the sensor by pressing on the locking tab to release it. To get the sensor out of the sump you will need to turn it counter-clockwise and then pull it out. To install the new sensor and reinstall the dishwasher under the counter follow the steps in reverse and once the dishwasher has been reinstalled turn the water back on and plug the power back in and the dishwasher should work now for you. I hope this helps. Thank you and have a great day!

Hello, Thank you for your question. You can test the turbidity sensor, this link shows resistance and specs- http://www.mouser.com/catalog/specsheets/920-480A_E_LR.pdf . You may also need to check your control board, if the timer is messed up it will not allow it to run properly. We hope this helps, good luck with this repair.

Hi Steve, Thank you for the question. On the side of the sensor there are tabs that stick out and the sensor will just push up into place and lock in with these tabs. Good luck with the repair!

Hi Lynn, thank you for reaching out. You will need to remove the dishwasher in order to replace the turbidity sensor. Glad to be of help!

Hi John, thank you for contacting us. Based on our understanding, the issue could be with the turbidity sensor's seal. It comes attached to the turbidity sensor, part number PS2363559. You may need to replace it to fix the issue. We hope this solves your problem!

Hi Lynn, thank you for getting in touch. We have concluded that the issue is because of the faulty turbidity sensor, part number PS2363559, replacing it will most probably to solve the problem. Glad to be of assistance!

Hi Whitney, Thank you for your inquiry. Before we can assist you further we would need the model number from your appliance. Thank you and have a great day!

Hi Sarah, Thank you for your question. If the dishwasher will not stop running there are some parts that you will need to check to see which ones are causing the issue. You will need to check the touchpad and the electronic control board, the motor, the heating element, the thermostat and the fill valve. I hope this helps. Thank you and have a great day!

Hi Randy, thank you for contacting us. Based on our research, the turbidity sensor, part number PS2363559, detects soil level in the water and sends the information to the control board. It tells the control board that the water is still dirty and needs to add more water to clean the dishes properly. We hope this information helps!

Hi Christopher, Thank you for your question. The gasket is sold with the turbidity sensor. We hope this helps!