Bake Element - 3500W 316415900

Hi Kevin, Thank you for the question. The manufacturer has assigned F8 error code to indicate a problem with the Oven Door Latch Motor and Switch. Try to unplug the appliance for about 10 minutes, if code returns check for mechanical issues with the latch, such as the latch arm pivot joint, rod, lever arm and spring. If those check out good, test the door latch switches for continuity and check the wiring to the switches. If you do not find the problem, you should replace the entire Oven Door Latch Motor and Switch.PartSelect Number: PS1528424. Hope this helps!

Hi Richard, thank you for your inquiry. We have researched your model and found that you can install the bake element without removing the back panel. In case one of the wires gets retracted into the opening at the bottom, you will need to remove the lower back panel to gain access to the wire terminals. We hope this helps!

Hello Mike, thank you for your query. According to our research, the part you have asked about is listed as compatible with your model. Sometimes the replacement parts may vary slightly in appearance, but these are the original and compatible parts made by the manufacturer. We hope this information helps!

Hi Monica, thank you for getting in touch. The bake element that you mentioned is approximately 15 3/4 inches wide and 15 1/2 deep with the terminals sticking out past the back 3 1/2 inches. Glad to be of assistance!

Hello Eric, thank you for your question. Using the ohmmeter, set the range scale on R x 1 and place the probes on the element terminals. There should be continuity, with readings ranging from 19 to 115 ohms. Readings will vary from manufacturer to manufacturer and according to unit size and the wattage. Good luck with your repair!

Hi Suzanne, Thank you for your question. The wire connectors may be the problem or it could be the new bake element. You will need to test the parts with a multimeter. Here is a link to one of our videos on YouTube that you may reference on how to use one, https://www.youtube.com/watch?v=bWC44fHn0As. I hope this helps. Thank you and have a great day!

Hello Tony, thank you for your question. The F10 code indicates there is an issue with the temperature sensor or the board. We would recommend testing the sensor, PartSelect Number: PS1528543. With the sensor at room temperature, measure the resistance between the two prongs at the end of the sensor connector. The resistance of the sensor should read approximately 1080 – 1090 ohms at room temperature. If that part is tested and is fine, the electronic board would have to be replaced. Good luck with your repair!