Washer Elements and Burners

Your Price

$53.00

Washer Heating Element

★★★★★

52 Reviews

PartSelect Number PS11742505

Manufacturer Part Number WP4391960

This element carries 5200W and 240V. Note: This element no longer includes two terminals and two adapter leads. They must be ordered separately.

Fixes these symptoms

Not Heating
See more...

Installation Instructions

Bill from Morristown, TN

Dryer quit heating. Suspected heating element was open

Unplugged the 220 volt source. Disconnected the vent line from the back of the drier. Removed the six screws holding the back panel with a 1/4 inch nut driver. Tipped the drier up at a 45 degree angle against the wall to give better access to the inside. Removed the screws holding the two thermostats to the side of the heater box and laid them aside. Disconnected the two red power lines to the heater element. Removed the large screw at the top of the heater box and removed the flexible bracket holding the heater box, then lifted the heater box up and away from the drier. Removed the one screw holding the heater element inside the heater box and pulled out the old heating element. The old element was open as found using an ohmeter on the two main terminals. Threw away the old element. Removed the new heating element from the box and slid it into the heater box making sure to align the terminal bracket with the hole in the heater box for the reinstallation of the mounting screw. Tightened this screw. Remounted the heater box to the two mounting slots and reinstalled the flexible mounting bracket to the top of the heater box and installed and tightened the large screw holding this bracket. Cut off and removed the old electrical push-on terminals from the two red power wires for the heater element. These were discolored and oxidated from the conducted heat over the years of operation. Using the supplied short red leads with push-on terminals already installed, I wire tied these new leads to the existing red power leads and pushed them onto the heater element terminals. Rechecked the soundness of the twisted wire connections to make sure they were tight. Replaced the back panel and reinstalled the six 1/4" screws with the 1/4' nut driever. Reinstalled the driver vent line and tightened its holding ring. Slid the drier back into position on the floor. Checked the level and readjusted the leveling legs for a steady floor stance. Reinstalled the 220 volt power connecter and set the controlls for a drying cycle. Let the drier run for aproximately 1 minute and then checked the air temperature inside the drier. IT WAS NOW PRODUCING HOT AIR. Project completed successfully and I was now a HERO in my wifes eyes. Absolutely no technical problems encountered. Just remember, unplug the drier before starting ANY repairs. To forget this COULD RUIN YOUR DAY. Read more...

Your Price

$175.48

Washer Heater Assembly

★★★★★

10 Reviews

PartSelect Number PS2378363

Manufacturer Part Number 131475320

This dryer heating assembly has 5/16" terminal on the housing.

Installation Instructions

CAROLE from MONTICELLO, AR

Dryer still turned, but would not heat

Had to remove tub to get to rear wall to make the repair and then put it back together in reverse order. Read more...

Your Price

$100.25

Washer Heater Assembly

★★★★★

4 Reviews

PartSelect Number PS3532212

Manufacturer Part Number AEG33121501

Installation Instructions

Andrew from BOTHELL, WA

TE error. Replaced heater / thermistor assembly.

removed top and front. heater is at the base of the tub. the nut compresses the rubber seal and may take some wiggling to remove the old one. Read more...