Amana Washer Dryer Combo Brackets and Flanges

Videos!

Your Price

$10.45

Amana Washer Dryer Combo Washer Spring Outer Bracket

★★★★★

1 Review

PartSelect Number PS11743348

Manufacturer Part Number WP64067

Sold individually.

Installation Instructions

Edward from Easthampton, MA

unbalanced load...knocking sound.

Unbalanced load was creating a knocking sound (as if the clothes load was unbalanced). Dismantled the washer to find that one brackets had rusted out. [FYI: 3 bracket at 120 degree apart (for the 360 degree circle)]. I found that the hole (on the bracket) where the spring holds was gone. Purchased parts. Replaced them (spring, bracket, screw). Reassembled washer then ran wash for a cycle. Successful fix. Read more...

Your Price

$27.25

Amana Washer Dryer Combo Bracket

PartSelect Number PS11756155

Manufacturer Part Number WPW10547294

Fixes these symptoms

Noisy
See more...

Your Price

$80.01

Amana Washer Dryer Combo Glide Bracket Kit

PartSelect Number PS2003560

Manufacturer Part Number 12002090

This kit contains two glide brackets and four screws.

Fixes these symptoms

Noisy
See more...

Installation Instructions

David from Underwood, IA

Loud banging sound. Worn out roller.

Pulled off the lower panel with 5/16 socket.Pulled off the door assembly by removing the two screws at the bottom of the door assembly. I pulled down a little and then out. be carefull of the wires. Other posts said to remove. The wires were long enough I did not have to remove them. I just leaned it against the wall. I then removed the 4 screws that hold the front piece in.pulled it off replaced brackets , installed self adhesive felt(stuck good) and then glides. Mine were thin but not the problem. I then reached under the drum and released the belt from the tensioner. I then pulled the whole drum out.This is the time to vacum out good. I could get to the rear rollers very easy. The left roller was shot and the shaft half wore into(the problem). I pulled off the two screws holding the roller support. Normally You have to remove the wheel with snap ring pliers first to remove the support. In this case snap ring long gone. Replaced support shaft, installed thrust washers and roller with grease for both sides. The right support shaft was still good. Removed tensioner pulley and inspected. It was just as good as the new one. Cleaned and greased and reinstalled. Put new belt on the tub and slid it back in. Be carefull to get the belt on the proper side of the tensioner. I then installed the front supprt in place to support the tub with the 4 screws. Spun the tub(felt good) then reached under and reinstalled belt to motor and tensioner. Spun again to check for belt alignment. (Check) Reinstalled door an lower panel. Test Quiet Sounds like new. Very easy! I hope this helps someone just as the other post has helped me. Blessings to all. Read more...