Gibson Dishwasher Spray Arms

Videos!

Your Price

$40.95

Gibson Dishwasher Lower Spray Arm

★★★★★

143 Reviews

PartSelect Number PS12585623

Manufacturer Part Number 5304517203

The Lower Spray Arm is used in your dishwasher to spray water and clean your dishes. If broken there will be visible damage or your dishes may no longer be cleaned properly. If your spray arm is broken (due to general wear or high heat), it should be replaced. Your lower spray arm will be located at the bottom of your dishwasher tub. Check your user manual and model number to ensure this model is right for you. This version is plastic and metal and comes in gray/blue. We recommend you wear work gloves to keep your hands safe when installing and disconnect power to the appliance. You will also want to make sure that you turn off the water supply to your dishwasher. From here, you will want to open the dishwasher, pull out the lower rack and set it aside. Remove the lower wash arm. On each side of the bottom of the spray arm, there are small locking tabs that can be pushed aside using a flathead screwdriver. Once released, the spray arm can easily be pulled off the dishwasher. Put the new lower wash arm in place and push it down to lock it in. Ensure it is spinning freely and does not hit the heating element. Return the lower dish rack into place and then close the dishwasher door.

Fixes these symptoms

Door latch failure
Leaking
Noisy
See more...

Installation Instructions

Donna from Madison, OH

spray arm keeps melting

I have had to keep replacing the spray arm on the bottom of my dishwasher which takes like 2 seconds to do.. First you open the dishwasher and than pull the bottom basked forward and reach down and pull the spray arm up and pop the bottom of the spray arm off and put it on the new spray arm and slip it back into the dishwasher over the thing that makes it spin around.. but the tricky part is and I didn't know this and this is why my dishwasher spray arm kept falling over and melting on the heating element.. you have to turn it till it clicks in.. and your done.. Read more...

Videos!

Your Price

$18.95

Gibson Dishwasher Lower Spray Arm Support

★★★★★

20 Reviews

PartSelect Number PS12712289

Manufacturer Part Number 5304518968

This lower spray arm is a genuine OEM part for various makes and models of dishwasher and is sold as an individual part. This part attaches to the lower spray assembly of your dishwasher and the lower spray arm itself clips into this part to facilitate its spinning movement during the washing cycle. To replace it, remove the spray arm by pulling it out, remove the surrounding circular clip and then twist to remove this bit. Made completely of plastic, this part measures approximately 3-inches deep, 2-inches wide, and 3.125-inches tall.

Fixes these symptoms

Leaking
Noisy
Not cleaning dishes properly
See more...

Installation Instructions

Dale from Worley, ID

spray arm fell off and melted on element

The Spray arm and the support had come off during operation and subsequently melted on the heating element. This was our fault, as a knife had slipped through the lower dish-rack and acted as a ramp to launch the spray arm as it came around. The support was a simple 1/4 turn counter-clockwise until it clicked into place, drop the strainer basket into position around the support, them push the spray arm into place until the catches snap over the retaining ring molded into the support. All told, about 10 minutes, max. Read more...

Videos!

Your Price

$24.95

Gibson Dishwasher Lower Spray Arm Support

★★★★★

12 Reviews

PartSelect Number PS9865072

Manufacturer Part Number 807145201

This plastic cover and stem assembly helps hold the lower spray arm in place.

Fixes these symptoms

Leaking
Noisy
Not cleaning dishes properly
See more...

Installation Instructions

Matt from Bowling Green, OH

Dishwasher was growing mold on inside lid door. Also the glasses were not looking clean. Appeared as if they were not getting rinsed well enough.

First I removed the two screws that hold the lower front cover of the dishwasher to get under the dishwasher. Then I removed the two screws that hold the element in place. I then pulled the element out about 3 inches and disconnected the two wires. I then opened the dishwasher door and removed the old element and replaced it with the new element. I closed the dishwasher door and reconnected the two wires making sure that I put the proper wire on the proper post. I then put the two screws back on the element to hold it in place Next I replaed the cover on the front and tested the dishwasher for heat by running it empty. Read more...

Videos!

Your Price

$43.95

Gibson Dishwasher Spray Arm

★★★★★

1 Review

PartSelect Number PS420713

Manufacturer Part Number 154313601

Depending on your model number, this spray arm is either the upper arm or center arm.

Fixes these symptoms

Leaking
Not cleaning dishes properly
See more...

Installation Instructions

ALAN from REDDING, CA

Upper spray arm kept falling during cycle

Place spray arm into receptacle. Take nut and screw on being careful not to over tighten. This will strip the spray arm and the same problem will occur. Easy fix! Read more...

Your Price

$61.95

Gibson Dishwasher Lower Tower Assembly

★★★★★

1 Review

PartSelect Number PS419978

Manufacturer Part Number 154156901

This tower helps force the water being propelled by the pump and motor assembly up to the spray arms for continuous water pressure during the wash cycle.

Installation Instructions

ROBERT from WOODSTOCK, GA

washer arm came off melted

washer asm came off due too a bad plastic nut removed pump houseing and then put on new arm and reinstalled pump houseing,, seemed pretty stright forward,, Read more...