All Installation Instructions for Kenmore Range 79070270400

burner hard to ignite, ports probably clogged

Simply lifted out the old burner assembly (no tools needed) and drop in the new replacement.

Parts Used:

Front Burner

J. Steven from Morristown, NJ
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

Thank you for voting!

Gasket In Door Replaced

The gasket just snapped in place. The first one I ordered was, my fault, the wrong one and I returned it and got the correct one two days later.

Parts Used:

Oven Door Seal with Clips

James from Greenville, TX
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

Thank you for voting!

55 yr old wall oven had burnt out seal

Very easy--just had to drill new holes for the clips because the are already pre set in the rubber gasket

Parts Used:

Oven Door Seal with Clips

Diane from Natrona Heights, PA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

Thank you for voting!

Bottom Panel of over rusted out.

Unplug the stove from the wall socket. Remove the oven door as shown in the instructions for replacing the door. This makes the job a lot easier. At the rear of the bottom panel there is a screw at each corner. Remove these screws, a screwdriver will loosen them, then remove by hand. If you have a convection oven remove the fan cover as this prevents the bottom panel from coming out. There is a screw at the top and the bottom of the cover. You can then gently lift the bottom panel at the rear and work it out of the front lip. Install the new bottom panel in reverse order.

Parts Used: