CG31200BDW Crosley Range - Instructions

I was pleasantly surprised that the knob I ordered from you was perfect. Your catalog picture/description was right on. I am so grateful I found your site. I looked @ others and they did not compare to your thorough description. Thank you.

Broke the same day I installed it

Pushed the knob on to the part that was sticking out. Knob fit perfectly...had to use a substitute part & wasn't sure it was the right part, so was pleasantly surprised!

Shut off the gas before you do anything! Remove the top front face cover by removing the four screws. Remove the three gas lines that go into the oven valve. remove the screws that hold down the manifold bar. Slide bar to the front and free from the burners and main valve. Remove the small bolt on the underside of the manifold that holds in the oven valve to the manifold. Remove old thermostat bulb from it's bracket inside the oven and pull through to the top of oven. Then remove the old valve. Remove rubber seals and transfer them to the new valve if you don't have new ones. Replace the new valve. Insert thermostat bulb on the end of the wire into the hole and down into the oven. Mount thermostat bulb into bracket. Then just reinstall in the same order that you took it apart. Then run the oven and check the new thermostat out to make sure it is working properly.

finished removing door seal, used pliers to remove old securing studs. positioned new seal and pushed securing studs into existing holes and was done.

Removed old knob and took new knob out of package and just slipped it on the stove. Less than a minute.

I couldn't find my model number U31EA-7 so I decided to go with a deferent model number U31FA-7 Pulled the old Knob off and pushed the new knob on and it works great

I have worked in maintenance field most of my adult life and all aspects and to change the oven door gasket was no challenge what so ever. It took longer to find my needle nose pliers to remove the old gasket clips and then re-install the new gasket. Maybe 10 minutes total

I think the installation instructions are fairly self explanatory. This is the second item I've ordered from Parts Select and I'm thrilled with their service. The items are always less expensive than other sites and they deliver what they promise. I would highly recommend them.

Popped in there real quick. Wish I would have done it sooner, my oven heats up much faster.

Removed stove from slot in wall. Bent rear left leg would not unscrew due to bent metal bracket. Used hacksaw to cut out leg, then straightened metal bracket with small hammer and was able to screw new leg in and adjust height by using level on stove before reinserting stove its slot. Recheck level after pushing back in place and adjust front legs if necessary. If not for bent metal receiving bracket, would have taken much less time. Still easy tho. R'cvd part in two days. Very quick.

This is a no brainer. I am only doing this because you asked. Pull out the stove, tilt it back, remove broken leg, install new leg.

Pushed on new knob. I was concerned temp markings would not be accurate so I purchased an oven thermometer. The markings were accurate to actual oven temp at 350 degrees so I am very happy with the replacement part. Thank You.