DBL333GB1WW General Electric Dryer - Instructions

All I did was stick the knob on. How easy was that! Knob works every time. Very pleased with the part.

Remove & rplace switch

Top control panel removed; next used screwdriver to lift up dryer top on each side( the top of dryer is attached by clips on the underside) the dryer front panel has two screws, one on each side of inside front(they are easy to reach and near the top of the inside front panel, after removing these two screws we used screwdriver again to pry off front panel as it is attached also by clips on inside of front panel. At this point there is easy access to the drum where the old belt was removed, new belt put in place; removed small panel on back of dryer to access idler pulley and attached new belt through the pulley; turned the drum a couple of times by hand to check if belt was running true on the drum; problem fixed.

Fortunately I watched the video on how to change the knob. I may not have noticed that the metal clip part of the old knob was still attached. Once the old part was removed, the new knob slid right into place.

Remove the top of dryer, remove switch after two wires removed. Snapped in new switch and hooked wires and then put top back on.

The old knob broke off & was no longer able to turn the pin to start the dryer. I simply slid the new knob onto the pin & it worked like new.

Took the knob and clip off the dryer and stuck the knew knob on!

very simple my husband put it on in no time