Enter the code USA15 at checkout to apply your discount. Discount will be applied at checkout when the code is entered & applies to all parts. Cannot be combined with any other coupon or special offer & cannot be applied to a previously placed order. Not valid toward tax or shipping & handling. Discount has no cash value. Discount expires on July 1 at 11:59pm EST.
You've Got 10% Off Your First Order!Save 10% with code at checkout *click to copy coupon code
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Instructions did not match the assembly of the ice maker.
I managed to move the auger far enough to allow me to insert the cup-drive and then realign the auger with the new cup-drive. I also have had one to break very shortly after installing it. This is my second part to replace and this one went really smooth, since I understood that the initial parts installation instructions did not apply on my ice maker.
Power, light, and clock work, micro/turntable not working
Much like the other post: 1. Removw vent case on top (3 screws) 2. Remove cover with control buttons (1 screw). 3. Removed bottom relay switch and replaced. Tight working space so be patient. Took 15 minutes Needle nose pliers used to crimp connector onto switch
Determining the root cause was fairly simple - but one should always identify the basic repair part first that may be the root cause - in this order - Diode - HV Capacitor - Magnetron due to costs of fixing the issue. I found that after replacing the two major components it may have been just the Diod/Rectifier a low coat resolution - but one never knows if the issue was one or many problems that wouldn't allow the Microwave to heat. The team at PartSelect was very helpful and was able to expidite the Magnetron to my residence to start the repair process KUDO's to the Customer Service Team!
My husband did it by just taking off the panel on the top of the microwave and replace old with new. We cleaned up some of the accumulated grease as well on the microwave. He had a little problem with the screws. We have done this before so no big problem. Thanks