SMH7175BC Maytag Microwave - Instructions

Use knife to peel back molding around latch openings. Pull down on plastic latch part, pull out bottom and tilt up to remove broken part from spring. Tilt top of new part inward and connect tab to spring. Push in bottom of latch and snap. Replace the molding by pushing all around the door frame.

Pulled out the old and inserted the new/replacement.

After removing the door from the OTR microwave, we slid out the old latch, slid in the new, & reattached the spring. Replaced the door & DONE.

Used a putty knife to take off the edging inside the door to have access to the latch. Put the new part in and attached the spring. Replaced the edging and job was complete.

Got part from you in one day - great- watched utube video on removing molding and reinstalling. Video was longer than time to fix all need to do was remove molding and install the door latch - it is made of plastic with a hook on which to attach spring. Hook breaks and therefore door does not close

Replaced with new motor from Parts Select. Part was a correct replacement for the old one. perfect fit. Works like it did when it was new. I will recommend Parts Select to anyone. Thank you very much. I would definitely use your company again in the future. I saved $30 by not using parts from GE.

I opened the section with a phillips screwdriver, unscrewed the bad bulb and replaced it with the good bulb.

replaced the drive motor and coupler coupler from samsung parts

Called Maytag regarding the latch. Was told I had to order an entire new door that would cost around $170 before shipping and handling. Went on partselect and foundt he part for $2.02. Big difference in price. Very easy to install. Hardest part was getting the spring back on. Would definitely recommend to friends.

hardest part was taking the microwave down off of the wall to gain access to the diode. Thought if was the transformer but ended up being just a blown diode. remove and replace and bench test. that part took 15 minutes . moral of the story don't boil water under the side of the microwave that holds the electric components.

took THERMOSTAT;NT-101NA,250 out and put THERMOSTAT;NT-101NA,250 in so easy got the part in LESS 19 HRS

Pulled off the old coupler (stem was broken), pushed on the new one... Voila!

Information provided on the web site by Part Select, were helpful and encouraging to select and buy the part needed to repair the appliance. No doubt, a skilled person having background in the repair of appliances should attend such repair job.