Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Very hard to close the door range, especially one way and it sticks to close.
First, view videos to know what is an active door range problem. Second, when you know the problem, see videos on you tube and be sure you will replace the right part Third, I go to Part Select, see reference video for your problem if you need and buy the part on line, good price, very quick delivery.
Pulled the range from the wall and unplugged the power cord. Cleaned the floor behind and under the stove. Removed the back plate of the control panel. Pulled the knob off and removed the wiring, I took a picture of how the old controller was connected to make sure I put all the wires on correctly. Removed the 2 screws in front the hold the controller. Installed the new controller in reverse order. On ours the wires would only fit on one way so the picture wasn't necessary.
Compressor would not shut off at the maximum recommended pressure (150psi)
Removed face plate (4 screws). Removed 2 screws holding manifold in place. Detached wires from the switch. No need to mark them - they don't have to go back on any particular terminal. Remove the switch from the manifold with an adjustable wrench. Replace with new switch (thread sealing compound on the new switch is sufficient - no need for teflon tape). Reattach wires and reassemble manifold and face plate. Easy fix!
Unplugged stove. Pulled stove out. Unscrewed screws and removed cover. Removed & replaced sensor. Reinstalled cover & screws. Plugged in stove and pushed back in. Only problem was when I pulled stove out, lid opened and disconnected the gas line to a burner.
The three braces under the coils had weakened and fallen apart
I simply pulled out the old coils and plugged in the new ones. I saved the little pieces that accompanied each coil, because I didn't know what they were used for.
The Range took forever to achieve the proper heating temperature with an inability to maintain a steady heat
I removed the bottom drawer,unplugged the Range and pulled it out to expose the rear cover panel. Using a nut driver (a screw driver can be used), I removed the rear panel to expose the Thermal fuse located almost dead center in the back of the Range. Unplug the two wires and loosen the screw holding it in position. Replace the thermal fuse, plug the two wires into the new part and replace the rear cover panel. Return the Range to its original position and plug it in. The job is done in less than 30 minutes.
Remove burner elements. Remove old drip pans. Thoroughly clean stove top under drip pan edges, and under top cover. Install new drip pans. Install burner elements. I never seem to be able to find the correct replacement drip pans at retail outlets in the quantities I need. Your parts identification, selection and ordering processes were simple and delivery was faster than I hed expected. Thank you
