All Installation Instructions for General Electric Washer Dryer Combo WSM2781WCWWW

Dryer making squeeky noise.

Removed the Drum and replaced the part....

Parts Used:

Rear Bearing

NICOLAS from LYNN, MA
Difficulty Level:
A Bit Difficult
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers, Wrench set

1 of 5 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

left a drywall screw in my pockit and it cut the tub

I first made a repaire order online and put on the service order that i needed a new tub.
Someone was to call me the the night before but i never got the call the service man was
coming between 8am and 12 he called at 11
and wanted to come and look at the washer to see what parts he needed i told him i put in the service reqwest that it needed a tub and that if he didn't have the tub not to come because i was not going to pay for a service call if he didn't have the parts he did tell me it would cost me $430.00 so i repaired it myshelf

Parts Used:

Tub and Bearing Assembly

Tub Seal Kit

Albert from Roselle, IL
Difficulty Level:
Really Easy
Total Repair Time:
1- 2 hours
Tools:
Screw drivers, Socket set, Wrench (Adjustable), Wrench set

8 of 33 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Dryer runs but no heat

I first checked the heating element by peeking through the peek hole in the front to see if it was turning on. The heating element turned on but gas failed to flow. Next, I checked all sensors including the fuse, they were all fine. This points to the solenoid as the cause of the issue. So I replaced the solenoids and the problem solved. I did watch the YouTube video on how to check the sensors and replace faulty parts.

Parts Used:

Gas Valve Coil Kit

Mitsuhiro from Anaheim, CA
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Screw drivers

Was this instruction helpful to you?

Thank you for voting!

Lack of grease caused bearing to go out

I took the top and front off the dryer. I then took the screws out of the drum and removed the drum. I then took the old bearing out and put the new one in.

Parts Used:

Rear Bearing

GARY from HALEYVILLE, AL
Difficulty Level:
Difficult
Total Repair Time:
1- 2 hours
Tools:
Screw drivers, Wrench (Adjustable)

Was this instruction helpful to you?

Thank you for voting!

Spin cycle not spining sufficient water from clothes

Remove front of unit. Replace belt that drives the washer. This repair is very easy.

Parts Used:

V-Belt

Bob from Riviera Beach, FL
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers

Was this instruction helpful to you?

Thank you for voting!

Dryer drum seized

Had to pry dryer front off drum because buttons had caught between glide and felt causing excessive heat that melted the glide to the felt. Removed old felt from dryer front and replaced glide then reassembled machine. Took longer overall time because I did not realize two glide parts were needed so repair was delayed until second glide was received.

Parts Used: