Door Mullion Spring DA81-01345B

Hi John, Thank you for your inquiry. The spring you referenced in your question to us is the correct part for your refrigerator. To place an order for it, you may order it online, through one of online chat sessions or by calling our customer service line and anyone would be happy to assist you. I hope this helps. Thank you and have a great day!

Hello Carl, Thank you for the question. The Sleeve, PartSelect Number PS4150923 is required for this model Hope this helps!

Hello Jim, thank you for your question. To remove the mullion bar, remove the two screws that hold the center hinge part number DA63-03454B, to the fridge door. When the screws are removed, gently pull up and out on the mullion bar, just a bit to remove it from the door. Gently pull the bar away from the door, but not too quickly, as there will be a wire harness connected behind that center hinge plate. Un clip the wire harness and the mullion bar will be free from the door. Reverse these steps to reinstall! I hope this helps!

Hello Beth, Thank you for the question. This does sound like an issue with the spring. The spring applies tension between components in the refrigerator, which engages and retracts the door flap. This will allow the door to close properly. Hope this helps, good luck with this repair!

Hi John, thank you for your question. I have listed that part below for you. Good luck with your repair.

Hello Carol, Thank you for contacting us. I have researched the model you have provided and have found the part you are looking for is PartSelect Number PS4163672. Samsung may have made changes to the spring on the appliance but they have advised this is the correct prong for your model. Thank you for your inquiry, good luck with this repair!

Hi Mike, Thank you for your question. Unfortunately we do not have an installation video on how to install this part. At the bottom of your mullion there is a little hole. That is where your spring is going to go inside of that little hole at the bottom. I hope that helps. Good luck with your repair.

Hi Bill, Thank you for your question. The spring is not sold separately and is only sold with the door support with mullion heater. The part number listed under your model number for the door support with mullion heater is PS4176674. I hope this helps. Thank you and have a great day!

Hello Don, thank you for your question. First, one error states that your defrost sensor has failed inside the refrigerator and needs to be replaced. The other says that your fan inside the refrigerator isn't moving properly. This will be caused due to the defrost sensor failing because the frost will block the airflow and hinder the fan from moving properly. That means that the back panel inside the refrigerator would need to be removed and all the ice/frost thawed out with a hair dryer. That will get the unit cooling normally again, but the defrost sensor must be replaced to stop the frost come coming back. Once that part is replaced you can press and hold the upper right and left control panel buttons together for 5 seconds and that will clear the errors on the screen. I hope this helps!

Hi Mike, Thank you for your question. The part number for the mullion door sleeve is PS4163673. No lubricant is needed. We hope this helps!