Frigidaire Washer Dryer Combo Motors
- Search your model number to find:
- Genuine OEM parts guaranteed to fit
- Free manuals and guides
- Repair instructions and videos
Popular Frigidaire Washer Dryer Combo Motors
Your Price
$168.76
In Stock
Frigidaire Washer Dryer Combo Motor
PartSelect Number PS16620747
Manufacturer Part Number 5304529782
This drive motor includes the pulley for the dryer drum belt. The motor has reverse threads for the blower wheel. Please disconnect the power before starting your repair. This is a genuine OEM part.
Fixes these symptoms
- Noisy
- See more...
Your Price
$150.44
In Stock
Your Price
$268.95
In Stock
Frigidaire Washer Dryer Combo 2-speed Motor With Pulley
PartSelect Number PS815490
Manufacturer Part Number 134159500
Fixes these symptoms
- Burning smell
- See more...
Installation Instructions
Helen from Madison, OH
Motor was overheating and kickins off during the cycle
After turning the water off and removing the hoses,I pulled the top off by removing the 2 screws from the clips in the back and popping the 2 spring clips in the front. I then removed the 2 side screws left and right to allow room for the sides to move out of the way of the motor. The back panel is spot welded so the panels stayed connected. I then removed the 2 screws from the water overflow guard on the motor. Once removed I unplugged the wire harness from the motor. After that the 4 nuts were taken off of the bottom of the motor. I pushed the belt tensioner in and pulled the motor out. Install the motor making sure the nuts are tight as they can work loose from vibration.
Read more...
Your Price
$173.95
In Stock
Frigidaire Washer Dryer Combo Motor Assembly
PartSelect Number PS12585125
Manufacturer Part Number 5304515840
Your Price
$183.86
In Stock
Frigidaire Washer Dryer Combo Motor With Pulley And Blower Housing
FIRST OF ALL DISCONNECT APPLIANCE
1. removing back acces panel to the motor (10" X 10" louver ) 2 screws
2. removing the front door by
a) removing the front panels between washer/dryer
b) removing front control panel 6 screws, pushing downward the panel and disconnecting all electrical junctions
c) remove (2) plastic plugs holding the lint collector from the door ( under the lint screen) using pliers.
d) removing 2 screws at bottom of door (previously covered by front panel) and 4 screws holding down the top panel and the door panel.
3. removing the blower housing 6 screws, + one on the exaust tubing, followed by the blower fan first removing the metal clip with pliers then (by inserting very small (2) screwdrivers under) its locking shaft (the 2 smaller of the 3 sections )you can slip the fan out.
4. removing the back panel of the fan housing 3 screws
5. removing the front and back motor holding clips (pliers) and disconnecting its electrical connector.
GIVE YOUR VACCUUM CLEANER A RIDE
Reinstalation is the reverse process, for the motor and the blower then just slip the belt over the drum (from the front) treading it into its motor wheel (through rear access panel) and tensioning it, replace al the open panel reconnecting all electrical connectors and don't forget to reconnect the clear pastic tubing into its switch actuator.
I did spend more than two hours as I had to explore first the whole assembly, now that I know it two hour should be more than enough, if you follow my instructions and you are a little handy 2 hour should be it. Read more...
PartSelect Number PS1150913
Manufacturer Part Number 5303937189
The pulley is no longer sold separately.
Installation Instructions
Marcel from Tampa, FL
motor shaft was cut out by the tension wheel arm of the belt
this problem resulted from the belt gone bad so here I replace both ( belt & motor )FIRST OF ALL DISCONNECT APPLIANCE
1. removing back acces panel to the motor (10" X 10" louver ) 2 screws
2. removing the front door by
a) removing the front panels between washer/dryer
b) removing front control panel 6 screws, pushing downward the panel and disconnecting all electrical junctions
c) remove (2) plastic plugs holding the lint collector from the door ( under the lint screen) using pliers.
d) removing 2 screws at bottom of door (previously covered by front panel) and 4 screws holding down the top panel and the door panel.
3. removing the blower housing 6 screws, + one on the exaust tubing, followed by the blower fan first removing the metal clip with pliers then (by inserting very small (2) screwdrivers under) its locking shaft (the 2 smaller of the 3 sections )you can slip the fan out.
4. removing the back panel of the fan housing 3 screws
5. removing the front and back motor holding clips (pliers) and disconnecting its electrical connector.
GIVE YOUR VACCUUM CLEANER A RIDE
Reinstalation is the reverse process, for the motor and the blower then just slip the belt over the drum (from the front) treading it into its motor wheel (through rear access panel) and tensioning it, replace al the open panel reconnecting all electrical connectors and don't forget to reconnect the clear pastic tubing into its switch actuator.
I did spend more than two hours as I had to explore first the whole assembly, now that I know it two hour should be more than enough, if you follow my instructions and you are a little handy 2 hour should be it. Read more...
Your Price
$172.95
In Stock
Frigidaire Washer Dryer Combo Remote Style Pump W/motor
PartSelect Number PS417325
Manufacturer Part Number 131268401
Use this with either a top load or front load washer. This pump has an horizontal mount.
Fixes these symptoms
- Leaking
- Will not drain
- See more...
Installation Instructions
Thomas from Walpole, MA
Pump Motor Failed
First, remove the 2 screws that hold the lower front cover in place, remove the cover and disconnect the plug and the ground wires from the pump. Next attach the washing machine drain hose to a wet vac, since even if the machine is empty, there will still be water in the outer tub and the pump. Suck the whole thing dry, remove the 2 bolts that hold the cover onto the pump, use a pliers to remove the 2 hose clamps, remove the hoses (no mess because of the vacuum). Remove the 2 screws that hold the pump to the base of the washer and remove the pump. Save the mounting bracket from the bottom of the pump. Orient the outlet on the new pump to match your old one if needed, instructions to do this are included with the new pump. Install the mounting bracket onto the new pump. Mount the pump to the washing machine base, reconnect the hoses, the cover and the wiring. Put the drain hose back into your drain. Run the machine, check for function and leaks. If all is well, replace the lower cover. Don't forget to tell your wife that the job was a whole lot harder than it looked.
Read more...
Your Price
$248.95
In Stock
Frigidaire Washer Dryer Combo Motor
PartSelect Number PS12365831
Manufacturer Part Number 5304514803
Your Price
$179.95
On Order
Frigidaire Washer Dryer Combo Motor
PartSelect Number PS12585073
Manufacturer Part Number 5304515226
Your Price
$268.95
In Stock
Frigidaire Washer Dryer Combo Drive Motor With Pulley
PartSelect Number PS815482
Manufacturer Part Number 134156400
This motor has 3/4 hp and 1 speed.
Your Price
$199.95
In Stock
Frigidaire Washer Dryer Combo Motor Cont Board No Housing
PartSelect Number PS12724039
Manufacturer Part Number 137469113NH
Introducing the Frigidaire MOTOR CONT BOARD, NO HOUSIN - a genuine OEM part designed to meet the needs of your laundry center. Showcasing its versatility, this valuable appliance component is adaptable to select models of Frigidaire, Electrolux, White Westinghouse, and Tappan. Notably, this particular item doesn't come with a control board housing, requiring you to transfer the original housing to the new board. Excelling in its functional role, it effectively monitors and controls the drive motor speeds and directions. Remember to always prioritize safety, so make sure to unplug your laundry center before installing this part and wear work gloves to safeguard your hands. You are sure to appreciate the ease and utility this Frigidaire part brings to your appliance maintenance.
Related Frigidaire Washer Dryer Combo Parts
- All Frigidaire Washer Dryer Combo parts
- Frigidaire Washer Dryer Combo Bearings
- Frigidaire Washer Dryer Combo Belts
- Frigidaire Washer Dryer Combo Brackets and Flanges
- Frigidaire Washer Dryer Combo Caps and Lids
- Frigidaire Washer Dryer Combo Circuit Boards and Touch Pads
- Frigidaire Washer Dryer Combo Dispensers
- Frigidaire Washer Dryer Combo Doors
- Frigidaire Washer Dryer Combo Drums and Tubs
- Frigidaire Washer Dryer Combo Ducts and Vents
- Frigidaire Washer Dryer Combo Elements and Burners
- Frigidaire Washer Dryer Combo Fuses
- Frigidaire Washer Dryer Combo Hardware
- Frigidaire Washer Dryer Combo Hinges
- Frigidaire Washer Dryer Combo Hoses and Tubes
- Frigidaire Washer Dryer Combo Knobs
- Frigidaire Washer Dryer Combo Latches
- Frigidaire Washer Dryer Combo Panels
- Frigidaire Washer Dryer Combo Pulleys
- Frigidaire Washer Dryer Combo Seals and Gaskets
- Frigidaire Washer Dryer Combo Springs and Shock Absorbers
- Frigidaire Washer Dryer Combo Switches
- Frigidaire Washer Dryer Combo Valves
- Frigidaire Washer Dryer Combo Wheels and Rollers
- Frigidaire Washer Dryer Combo Wire Plugs and Connectors