Whirlpool Washer Wheels and Rollers
- Search your model number to find:
- Genuine OEM parts guaranteed to fit
- Free manuals and guides
- Repair instructions and videos
Popular Whirlpool Washer Wheels and Rollers
Your Price
$18.88
In Stock
Whirlpool Washer Dryer Drum Support Roller
2. pop off top of unit
3. remove front of dryer
4. lay unit on its back
5. remove drum and replace pulley assembly,belt,drum rollers of which it has 2 rear and 2 front
6. reverse above and then remove filter-vent housing and scrape off old seal install new seal
7. re-connect power,gas and vent use again
8. only sad part to whole job was seeing how cheaply whirlpool now makes thier products Read more...
PartSelect Number PS11752609
Manufacturer Part Number WPW10314173
This drum support roller is sold individually. Most dryers require two. The tri-rings are included. This is a drum support roller for a dryer. It is a genuine replacement part. This part is sold separately. Most dryers require two drum rollers. It is recommended to check and replace both drum support rollers at the same time to ensure proper drum rotation and because they often wear at the same rate. The drum support roller holds the drum in the proper position while it spins on the support wheels. If rollers are worn out, they will cause the dryer to be noisy.
Fixes these symptoms
- Drum Not Spinning
- Marks left on clothes
- Noisy
- See more...
Installation Instructions
Jeff from Phoenix, AZ
noisy and slow drum speed
1. disconnect power,gas and vent lines2. pop off top of unit
3. remove front of dryer
4. lay unit on its back
5. remove drum and replace pulley assembly,belt,drum rollers of which it has 2 rear and 2 front
6. reverse above and then remove filter-vent housing and scrape off old seal install new seal
7. re-connect power,gas and vent use again
8. only sad part to whole job was seeing how cheaply whirlpool now makes thier products Read more...
Your Price
$49.30
In Stock
Whirlpool Washer Dryer Drum Roller Shaft Left Side
Most sites said the support rollers could cause this.
I found your site PartSelect and with help of your diagrams of the machine ordered the parts I thought were needed plus other parts that might cause the problem.
With machine torn down I replaced the rollers.
I had also ordered the main drive belt and idler assembly with the rollers and these also needed replacement. It is a good idea to order other suspect parts when doing this type of repair since you can return the parts not needed.
Your return policy is great.
Edward Brennan Read more...
PartSelect Number PS11753706
Manufacturer Part Number WPW10359270
Replace the shaft of your left side drum support roller with this part from Whirlpool/Kenmore. This replacement shaft is 2-7/8 inches long. It is meant for use with many of Whirlpool/Kenmore's gas and electric clothes dryers that have been manufactured since 1965. Also known as Drum Roller Shaft.
Fixes these symptoms
- Noisy
- See more...
Installation Instructions
Edward from Andover, NJ
Dryer was sqeaking loudly when running
I Looked on internet sites for this type of problem.Most sites said the support rollers could cause this.
I found your site PartSelect and with help of your diagrams of the machine ordered the parts I thought were needed plus other parts that might cause the problem.
With machine torn down I replaced the rollers.
I had also ordered the main drive belt and idler assembly with the rollers and these also needed replacement. It is a good idea to order other suspect parts when doing this type of repair since you can return the parts not needed.
Your return policy is great.
Edward Brennan Read more...
Your Price
$49.31
In Stock
Whirlpool Washer Dryer Drum Support Roller Shaft Right Side
Most sites said the support rollers could cause this.
I found your site PartSelect and with help of your diagrams of the machine ordered the parts I thought were needed plus other parts that might cause the problem.
With machine torn down I replaced the rollers.
I had also ordered the main drive belt and idler assembly with the rollers and these also needed replacement. It is a good idea to order other suspect parts when doing this type of repair since you can return the parts not needed.
Your return policy is great.
Edward Brennan Read more...
PartSelect Number PS11753705
Manufacturer Part Number WPW10359269
Replace the shaft of your right side drum support roller with this part. This replacement shaft is 3-3/16 inches long, but does not require a washer or a nut.
Fixes these symptoms
- Noisy
- See more...
Installation Instructions
Edward from Andover, NJ
Dryer was sqeaking loudly when running
I Looked on internet sites for this type of problem.Most sites said the support rollers could cause this.
I found your site PartSelect and with help of your diagrams of the machine ordered the parts I thought were needed plus other parts that might cause the problem.
With machine torn down I replaced the rollers.
I had also ordered the main drive belt and idler assembly with the rollers and these also needed replacement. It is a good idea to order other suspect parts when doing this type of repair since you can return the parts not needed.
Your return policy is great.
Edward Brennan Read more...
Your Price
$62.32
In Stock
Whirlpool Washer Blower Wheel
PartSelect Number PS2052494
Manufacturer Part Number 56000
If your dryer is noisy, will not tumble, or is not producing enough heat, you may need to replace the blower wheel. This part is white in color, and is made of plastic. This part is approximately 8 inches in diameter. The blower wheel is located near the bottom of your dryer cabinet. To access it for this repair, you will need to remove both the front panel and the front bulkhead assembly. Before you begin this repair, be sure to disconnect the power source to the dryer. To complete this repair, you will need a 5/16 inch nut driver, a 1/4 inch nut driver, a pair of locking pliers and a 7/8 socket with a short extension and a ratchet.
Fixes these symptoms
- Noisy
- See more...
Installation Instructions
Rick from Birch Run, MI
Blower fan cracked
Unplug the power cord from the unit. Remove the lower front panel; then the upper front panel including the door (unplug wire to door switch). Then remove the cover on the fan housing. Need to block the motor from turning; I used a stick to jamb the front of the motor; then unscrew the old blower fan and screw on the new one. Then replace the cover and put front panels back on.
Read more...
Your Price
$12.95
In Stock
Your Price
$9.95
In Stock
Your Price
$45.11
In Stock
Your Price
$66.47
In Stock
Whirlpool Washer Idler Pulley Shaft
PartSelect Number PS11742857
Manufacturer Part Number WP56461
This shaft is made to fit the center of the idler pulley wheel of many clothes dryers. It is less than two inches long, and is made of metal.
Fixes these symptoms
- Noisy
- See more...
Installation Instructions
Brian from Yucaipa, CA
Screeching sound coming from back of the dryer.
First removed the bottom access panel, then the then pried the top lid open. Then, I could get to the four screws holding the front of the drum in place. Once that was removed, reached underneath drum and disconnected belt from tensioner pulley and motor. Removed the drum and discovered the problem. One of the two drum rollers had completely disintergrated from the shaft, actually "melting" off of its roller shaft. Removed both of the rollers and shafts by putting a flathead screwdriver on the slot of the shaft, and at the same time holding the locknut behind the bracket with a box wrench. I replaced both shafts and rollers and reused the same washers and snaprings. I used a screwdriver and a vice to remove the snap rings off of the old shafts. The best bet is to use a pair of snap ring pliers, which I didn't have. I used some white silicone grease to lube the new rollers up, reinstalled them and replaced the belt. You MUST route the belt around the drum before you install, then connect the belt to the motor underneath and wrap it around the tensioner. While I had everything opened up, I shop-vac"d the inside of my dryer(filthy). I did this before putting anything back together. Also, when re-installing the front dryer panel, make sure the motor inlet and the lint outlet tube form an airtight seal. All in all, this was a fairly strightforward job. The dryer now works great and is as quiet as a mouse.
Read more...
Your Price
$72.95
Special Order
Whirlpool Washer Rolling Laundry Supply Cart
PartSelect Number PS1559850
Manufacturer Part Number 1903WH
This Rolling Laundry Supply Cart includes three shelves for ample storage of detergents, fabric softeners, and other items you need while doing laundry. An accessory, this plastic cart stores easily between your washer and dryer. Size: 30-3/4" H x 25" L x 8-1/3" W. Assembling this accessory will require basic hand tools, but no prior repair experience.
Your Price
$10.95
In Stock
Related Whirlpool Washer Parts
- All Whirlpool Washer parts
- Whirlpool Washer Agitators
- Whirlpool Washer Bearings
- Whirlpool Washer Belts
- Whirlpool Washer Brackets and Flanges
- Whirlpool Washer Caps and Lids
- Whirlpool Washer Circuit Boards and Touch Pads
- Whirlpool Washer Dispensers
- Whirlpool Washer Doors
- Whirlpool Washer Drawers and Glides
- Whirlpool Washer Drums and Tubs
- Whirlpool Washer Electronics
- Whirlpool Washer Elements and Burners
- Whirlpool Washer Filters
- Whirlpool Washer Handles
- Whirlpool Washer Handles and Latches
- Whirlpool Washer Hardware
- Whirlpool Washer Hinges
- Whirlpool Washer Hoses and Tubes
- Whirlpool Washer Knobs
- Whirlpool Washer Latches
- Whirlpool Washer Legs and Feet
- Whirlpool Washer Lights and Bulbs
- Whirlpool Washer Motors
- Whirlpool Washer Panels
- Whirlpool Washer Power Cords
- Whirlpool Washer Pulleys
- Whirlpool Washer Pumps
- Whirlpool Washer Seals and Gaskets
- Whirlpool Washer Sensors
- Whirlpool Washer Springs and Shock Absorbers
- Whirlpool Washer Switches
- Whirlpool Washer Timers
- Whirlpool Washer Transmissions and Clutches
- Whirlpool Washer Valves
- Whirlpool Washer Wire Plugs and Connectors